GARAN EWS-102 Настройка системы - Страница 3

Просмотреть онлайн или скачать pdf Настройка системы для Блок управления GARAN EWS-102. GARAN EWS-102 4 страницы.
Также для GARAN EWS-102: Настройка системы (4 страниц), Настройка системы (4 страниц), Калибровка и настройка (8 страниц), Дополнительная информация (2 страниц)

EWS-102 CONTROL UNIT

To begin the system setup,

press the

and

buttons together

Press the

Load Calibra�on

A�er placing the known load within the elevator cabin, press the

When the dashes are displayed, set the value of the required load in kilograms. Use the

select the required digit (selected digit flashes) and use the

For example: Using a known load of 75Kg

To complete the ac�on, press the

Countdown

The instruments then counts down from 10 to 1

Upon comple�on, the screen will display

return to Opera�on Mode. The load has now been calibrated.

Firmware 5.5 Rev 2 Booklet subject to alteration

bu�on to enter load calibra�on menu

x 7

x 5

bu�on

Mul� Analog version only: See note 3 page 1. A�er the EWS 102 calibra�on

and setup has been completed, place the the li� at the lowest floor level and

rezero following the process on page 2, this will finalise the Analog output

calibra�on.

CALIBRATION LOAD

Bu�on to proceed.

bu�on to set the required digit value.

CAL

for approximately 10 seconds and then the system will

www.garan.co.uk

bu�on to

www.garan.co.uk

Page 3