Avantgarde TRIO G3 Руководство пользователя - Страница 14
Просмотреть онлайн или скачать pdf Руководство пользователя для Динамики Avantgarde TRIO G3. Avantgarde TRIO G3 18 страниц.
Печатать страницу
OPERATION - SPACEHORN
DSP USER INTERFACE
+4
+3
1 6
+2
+1
EQ SETTINGS
–1
–2
–3
–4
1 1
1 2
BASS GAIN
BASS BOOST
1 3
1 4
LPF – RANGE
OFF
1 5
FILTER 1
–3dB
–6dB
OFF
FILTER 2
–3dB
–6dB
� Please note that all changes in the Avantgarde control software
immediately become audible in the speaker. This way it is easy
to verify the changes by listening and f ine adjust if required.
30Hz
40Hz
60Hz
80Hz
110Hz
160Hz
220Hz
320Hz
0
0
1
2
3
4
5
6
30Hz
40Hz
60Hz
80Hz
110Hz
160Hz
220Hz
320Hz
OPERATION - SPACEHORN
DSP SETTINGS
The BASS GAIN slider
The BASS BOOST slider
below 45 Hz. This allows to tailorize the bass response f rom "linear"
to "fat".
For individual f requency settings use the 8 x band equalizer
Each of the 8 x bands can be increased or decreased by up to 4dB.
This can be used to tailor your bass response to specif ic sounds
7
(linear, techno, disco, pop, etc.) or to reduce some wide–band room
resonances.
The LPF–RANGE slider
subwoofer. The crossover f requency in its factory setting is linear.
The f requency response of the subwoofer seamlessly crosses over to
the f requency response of the midrange horn. Both response
curves do not overlap and there is no gap inbetween. The crossover
point can be used to adjust the "tonal balance" of the system.
When set to a higher f requency, the subwoofer will partly overlap
1
with the midrange horn response. This will add "warmth" and give
a richer "body" to the sound character of certain voices and
instruments.
2
If the crossover f requency is purposely set to a lower f requency,
subwoofer and midrange f requency response will have a small gap.
The tonal balance of the system will shift to a more horn typical
"dynamic" and "punchy" sound.
FILTER 1 & 2
of –3dB or –6dB. These f ilters can be used to elimante/reduce
unwanted narrow band resonance f requencies of the room.
Use commonly available f requency sweep apps to detect the
1
position (Hz) of possibly available room modes. Or play music
through your system and slowly slide the FILTER set at –6dB
upwards until the "boominess" improves.
26
27
sets the overall volume of the subwoofer.
increases the low f requency response
sets the upper crossover f requency of the
are narrow band notch f ilters with a negative gain
.