Avantgarde TRIO G3 Руководство пользователя - Страница 16
Просмотреть онлайн или скачать pdf Руководство пользователя для Динамики Avantgarde TRIO G3. Avantgarde TRIO G3 18 страниц.
Печатать страницу
FINE TUNING
LISTENING HEIGHT
Depending on the listening distance and the height of your seat it
1
might be important to raise or lower the speaker systems. Ideally
your ears are in level with the height of the centre of the tweeter
2
(approx. 110 cm above ground).
If not, slightly incline the speaker forward or backward by turning
the knurled screw
pointing at you.
RUN–IN TIME
Brand new horns and subwoofers usually need at least 40 hours of
running–in.
During
continuously. Please leave the subwoofers ON during this run–in
period.
After this run–in, the sound might have been altered and it might
be necessary to slightly re–tune the system set–up (positioning and
subwoofer-settings).
WARM–UP TIME FOR ITRON
The ITRON electronics uses pure CLASS–A circuits with Zero–
Feedback. To reach its full sonic potential the components need to
be fully warmed–up. A suff icient warm up time (> 15 minutes) prior
to serious listening is recommended.
of the spike assembly
till the tweeter is
this
period
sound
quality
will
MISCELLANEOUS
12V DC TRIGGER
The 12V DC TRIGGER sockets of the ITRON & SPACEHORN electron‐
OUT
IN
ics features an "IN"–socket
1
2
is easily possible to remotely switch ON/OFF additional devices (ad‐
TRIGGER
ditional SPACEHORNS etc.) by simply daisy–chain the 12V trigger
12V DC
signal.
� Wiring can be made with single-stranded or stereo jack cables.
E–FUSE
All Avantgarde electronics are equipped with a state–of–the–art
electronic protection circuit. This E–FUSE continuously monitors
improve
the unit and in the event of a fault immediately interrupts the flow
of current with unrivaled precision & speed and thus protects the
device f rom damage.
2
1
When the E–FUSE has tripped, the current flow will be interrupted
ENGAGED
and the device stops operating. The red engaged fuse LED
FUSE
E FUSE
illuminate. Press the E–FUSE button
RESET
stops again, a permanent malfunction has occurred. Disconnect the
device f rom the mains and get it serviced by your dealer.
3
All Avantgarde electronics are equipped with a mains ON–OFF
power switch that includes an external fuse holder
avoid any kind of sound degradation, the usual glass–fuse is
replaced as standard in all Avantgarde E–FUSE controlled devices
by a massive copper bolt to bridge the power.
For whatever reason this copper bolt may at any time be replaced
by a conventional 2.5 amp slow blow glass fuse.
FUTURE UPGRADES
Your system has already been equipped with a wif i antenna port to
support future upgrades. This includes remote control signals (f rom
apps etc.) and receiving OTA (over the air) update f iles for the
f irmware of the built–in controller chipset.
� Future options only; not available upon release.
30
31
and an "OUT"–socket
. This way it
will
to reset. If the E–FUSE
. In order to