Jandy Jandy Pro Series Руководство пользователя - Страница 6

Просмотреть онлайн или скачать pdf Руководство пользователя для Системы фильтрации воды Jandy Jandy Pro Series. Jandy Jandy Pro Series 12 страниц. Single element cartridge pool & spa cs filters
Также для Jandy Jandy Pro Series: Руководство по установке (16 страниц), Руководство по установке и эксплуатации (20 страниц), Руководство пользователя (20 страниц), Руководство (8 страниц), Краткое руководство по эксплуатации (2 страниц), Руководство по установке и эксплуатации (20 страниц), Инструкции по установке (2 страниц), Руководство по установке и эксплуатации (16 страниц), Руководство по установке и эксплуатации (16 страниц), Руководство по установке и эксплуатации (16 страниц)

Печатать страницу
Jandy Jandy Pro Series Руководство пользователя
Page 6
2.2

Installing the Light Fixture

NOTE Perform these steps only after the electrical system requirements
are met.
1.
Feed cord through electrical conduit to junction box, leaving at least
fourteen (14) inches of slack cord in the conduit near the pool wall to
allow for winterization. See Figure 1.
2.
Remove the docking ring from the light and attach the docking ring to
the 1.5" pool fitting. See Figure 2.
1.5" Plastic Fitting (Not Included)
Figure 2.
Install the docking ring securely to the 1.5" pool wall fitting
3.
Cut the cord at the junction box, leaving at least six (6) inches of cord
to make connections.
4.
Strip six (6) inches of the outer cord jacket to expose the two insulated
wires being careful not to damage any remaining insulation.
5.
The light mounts to the docking ring by turning it clockwise onto the
docking ring and securing it with the provided screw. See Figure 3.
6.
Fill the pool until the underwater light is completely submerged
in water before operating the light. Turn on main switch or circuit
breaker, and the switch, which operates the underwater light, to check
for proper operation. Refer to Section 4, Operating Instructions.
7.
Properly prepare the end of the light cable to securely connect it to the
12VAC output of a Class 2 transformer that is listed or certified by a
Nationally Recognized Testing Laboratory (NRTL) for the intended
use.
ENGLISH
Nicheless Underwater LED Lights | Owner's Manual
Nicheless Underwater LED Lights | Owner's Manual
Docking Ring