Empire Trracer Руководство пользователя - Страница 4
Просмотреть онлайн или скачать pdf Руководство пользователя для Оборудование для пейнтбола Empire Trracer. Empire Trracer 12 страниц.
Печатать страницу3. Getting Started
Safety and safe marker handling are the most important aspects
of paintball sports. Please practice each of the following steps with
an unloaded marker before attempting to operate your marker
with an air source and paintballs.
• Do not install an air source or load paintballs into your marker until
you have completely read and understood this manual and feel
completely confident with your ability to handle your marker safely.
• Always use ASTM-approved paintball-specific eye protection.
Always wear eye protection
when handling a paintball
marker and in any areas
where paintball markers
may be discharged.
• Keep your finger out of the
trigger guard and away
from the trigger; point the
muzzle of the marker in a
safe direction at all times.
Keep the marker in safe
mode.
• Always keep your marker
pointed in a safe direction
and use a barrel-blocking
device.
• Remember that the ulti-
mate safety device is you,
the operator.
2
Safety and Safe Mode
The safety is a small mechanical slide on the left side of the mark-
er above the trigger. When the safety is "Off", a red dot is visible
on the marker (Fig. 3.1). When the Safety is "On", no red dot will be
visible and the marker will not fire (Fig. 3.2).
In this manual, you will see the term "safe mode". In "safe mode",
the safety should be set to "safe" (red marking on safety will not be
visible) and a barrel-blocking device should be installed. Make sure
your marker is in "safe mode" when the marker is not being fired
or when indicated to do so.
Feed Elbow Installation
• Install the feed elbow before installing the barrel.
• Press and hold the retention button located on the side of the
feed elbow.
• Slide the elbow onto the front of the Picatinny rail.
• Line up the elbow with the feed hole on the right side of the
body.
• Check that the elbow is locked in place, properly aligned, and
that the spring-loaded retention button is lined up with a gap
on the Picatinny rail.
Fig. 3.1
Barrel Installation
• Make sure marker is degassed, loader removed, no paintballs in
the feed port or breech, and the marker is in "safe mode".
• While pointing marker in a safe direction, slide the barrel
through the pump handle and thread into the front opening of
the marker body.
• Turn the barrel clockwise until it stops (do not over tighten).
• Install a barrel-blocking device. This can be a barrel plug or
other such device that prevents the accidental discharge of a
paintball.
Fig. 3.2
E M P I R E P A I N T B A L L . C O M