Gardena EasyCut 400 Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Триммер Gardena EasyCut 400. Gardena EasyCut 400 14 страниц. Gardena electric hedge trimmer operating instructions
Также для Gardena EasyCut 400: Руководство по эксплуатации (10 страниц), Руководство по эксплуатации (10 страниц), Руководство по эксплуатации (10 страниц), Руководство по эксплуатации (7 страниц), Руководство по эксплуатации (10 страниц), Руководство по эксплуатации (15 страниц), (Французский) Руководство по эксплуатации (8 страниц)

Печатать страницу
Gardena EasyCut 400 Руководство по эксплуатации
Trimming overhanging
lawn edges :
Starting the trimmer :
K
L
Filament feed
(Tip mechanism) :
ComfortCut 450 / PowerCut 500 :
1. Setting the plant guard
to parking position (see
"Adjusting the plant guard" ).
2. Set handle angle to position 3
(see "Setting the working
position" ).
I
3. Push slider
J
turn handle
I
and let slider
place (see arrows
articulated fork and handle
holder).
EasyCut 400 / 480 :
v Open clamping lever
turn upper part of handle
through 180° and close
clamping lever
Switching the trimmer on :
1. Press and hold the safety lock
the start button
2. Release the safety lock
Switching the trimmer off :
v Release the start button
The tip mechanism works when the motor is running. A clean
cut is only achieved with the maximum filament length.
1. Start the trimmer.
2. Hold the cutting head
parallel to the ground and
tap the trimmer with the
2
cutting head
ground (avoid sustained
2
pressure).
The cutting filament
switching process and adjusted to the correct length with the fila-
N
ment limiter
. If necessary tap several times one after the other.
H
upwards,
through 90°
lock into
z
on
P
E
,
8
E
again.
E
K
and then press
L
on the handle.
K
again.
L
on the handle.
2
on the
M
is automatically lengthened with an audible
J
z
P
I
H
8
N
M
15