Gardena 6000/6 inox Premium 1736 Руководство по эксплуатации - Страница 8

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Газонное и садовое оборудование Gardena 6000/6 inox Premium 1736. Gardena 6000/6 inox Premium 1736 17 страниц. Garden pump
Также для Gardena 6000/6 inox Premium 1736: Руководство по эксплуатации (10 страниц), Руководство по эксплуатации (12 страниц), Руководство по эксплуатации (14 страниц), Руководство по эксплуатации (10 страниц), Руководство по эксплуатации (10 страниц)

Печатать страницу
Gardena 6000/6 inox Premium 1736 Руководство по эксплуатации

7. Trouble-Shooting

Free the
impeller:
"
Cleaning the flow sensor:
D
H
C
F
E G
Problem
Pump runs, but the suction
action doesn't take place
DANGER! Electric shock!
Risk of injury due to electric shock.
v Disconnect Garden Pump from the mains before
trouble-shooting.
An impeller blocked by dirt can be freed again.
v Turn the impeller bolt
This will free the blocked impeller.
If the flow sensor is dirty, this may result in spurious error
messages (LED flashes orange).
1. Unscrew both screws
2. Remove the cover
r
3. Undo the screw
and detach the clip
t
4. Unscrew the cap
u
5. Remove the impeller
flow sensor.
6. Re-fit the impeller
i
direction.
7. Screw the cap
into place clockwise.
u
8. Secure the cap
by way of the clip
u
9. First insert the cover
two screws
at the bottom.
e
Possible Cause
Pump sucks in air at a joint.
Leaky or damaged suction
hose.
The pump was not filled with
the liquid to be pumped.
The liquid escapes over the
hose which is connected to
the delivery side during the
suction action.
Absolutely vacuum-resistant connection is achieved by using
GARDENA Suction Hoses (see point "8. Available accessories").
using a screwdriver.
w
.
e
.
.
z
anticlockwise.
and clean it. Clean the housing of the
i
with the metal part in the mounting
using the screw
z
at the top and then tighten the
r
Remedy
v Seal connections on suction
side so are airtight.
v Check suction line for damage
and seal so is airtight.
v Fill the pump
(see "4. Operation").
1. Fill the pump again
(see "4. Operation").
2. When starting operation hold
the pressure hose approx.
1 m vertically above the
pump, until the suction
action has taken place.
.
t
19