A&E Systems Electrolux AW300 Руководство по установке и эксплуатации - Страница 4
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Аксессуары A&E Systems Electrolux AW300. A&E Systems Electrolux AW300 8 страниц. Direct mounting case awning for mini-motorhomes, pick-up campers, vans, van conversions & pop-up tent trailers
BOTTOM
MOUNTING
BRACKET
10. Re-attach Foot to Bottom Mounting Bracket. Loosen
Lock Knob on Arm Assembly. Raise Inner Arm as high
as it will go. Then tighten Lock Knob. Fig. 10.
NOTE: Make sure Lock in top of awning Arm Assembly
clears top of Case Lip. Fig. 9C.
This is necessary for awning to open properly.
Repeat for other side.
11. Using Wand, hook Pull-Strap and pull awning out about
11.
3 feet (1 meter). Fig.
12. While securely holding the Pull-Strap, tighten the Loc
Knobs on the Rafter Arms. Fig. 12.
13
CASE
BACK WALL L OF
AWNING CASE
13. A.
On the back wall inside the awning Case,
measure in from edge of End Cap 1 inch (3
cm) and up 1/2 inch (2 cm) from bottom edge
of back wall as shown in Fig. 13, and mark this
location.
B.
Drill a 3/16"(5mm) Dia hole through the back
of the awning Case and into the vehicle.
Repeat for other side.
11
AWNING
k
14
X14 PHILLIPS
PAN HEAD
SHEET METAL
SCREW
15. While holding Pull-Strap firmly, release Lock Knobs on
Rafter Arms and allow awning to roll up. Fig. 15.
Awning Case should close tightly.
16A
SIDE VIEW
AWNING CLOSED
LIP
OF
CASE
16. For correct installation, Lock in top of awning Arm
Assembly must clear top of Case Lip. Figs. 16Aand 16B.
NOTE: For proper operation it is very important for
Lock to clear top of Case Lip.
17
AWNING
17. Using Wand, check to see if awning opens and closes
correctly by pulling awning open about 3 feet (1 meter).
Fig. 17.
Open and close awning 2 to 3 times.
When awning is at proper setting and operates correctly,
mark location of arm setting on Inner Arm Assembly
with supplied arrow labels. Fig. 18.
Repeat for other side.
4
16B
SIDE VIEW
INNER
- A R M
ADD ARROW
.FOR CLOSING
POSITION
OUTER
- A R M