Alke Global-8 Series Руководство по эксплуатации и установке - Страница 4

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и установке для Нагреватель Alke Global-8 Series. Alke Global-8 Series 17 страниц.

General information

Model identification

The main identification of the different models is Global-5 and Global-8. These are independent

atmospheric stainless steel infrared heaters. Suffixes are used behind these model names to add

additional type information about the models (e.g. Global-5 CETETHi).

CE:

that particular type is CE approved

DS:

equipped with a dual dust filter connection

TE:

equipped with a thermocouple safety device

TH:

equipped with an independent thermostat and remote sensor (1,25 meter long)

THi:

equipped with an independent thermostat and integrated sensor

DI:

double injection system

MK:

solenoid valve for hi-low application on 24VAC or 230VAC

Packaging

Normally (depending model and order quantity) the heaters are packed per 1, 2 or 4 in a box. Always

check the heaters for transport damage directly after receiving them. Note that the heaters will be a bit

discoloured by temperature due to a 5 minutes quality check after manufacturing.

The heaters are pre-assembled. In some cases, if there is a risk for damaging during transport, the

thermocouple sensor is separated from the gas safety device. Re-assembly can be simply done by

screwing the M8 nut (18) of the sensor back on the safety device (17). Do not tighten too strong.

In most cases the reflector is delivered separately from the burner part to save on transport costs.

Reassembly is easy: move the burner tube through the hole in the reflector. Slide the reflector over the

tube till it rests on the upper plate of the burner. Secure the reflector with 4 nuts and washers and 2 eye

bolts.

The thermostat knob is always delivered separated from the thermostat valve.

1) Remove the protection cover from the thermostat valve.

2) Turn the knob on maximum temperature and push the knob on the valve.

3) Fix the knob by turning the large metal screw ring till it stops (at least 2 turns, hand tight).

For thermostats with a remote sensor only: bend the sensor line carefully (no sharp bends) to the

thermostat valve and secure the sensor line with a ty-rap around the red protection lining and the

thermocouple safety device (see picture). Note that the tubing is hollow, a sharp bend will close the

tubing and makes the sensor worthless. The chance of breaking the line at the entrance of the

thermostat knob is largely limited now.

Version: April 2016

manual number: 0009 0440EN