Garmin GPSMAP 5208 - Marine GPS Receiver Руководство по установке - Страница 6

Просмотреть онлайн или скачать pdf Руководство по установке для Морская система GPS Garmin GPSMAP 5208 - Marine GPS Receiver. Garmin GPSMAP 5208 - Marine GPS Receiver 25 страниц. Weather and xm satellite radio gpsmap 4000 series; gpsmap 5000 series; gpsmap 6000 series; gpsmap 7000 series
Также для Garmin GPSMAP 5208 - Marine GPS Receiver: Важная информация по безопасности (4 страниц), Краткое справочное руководство (2 страниц), Руководство пользователя (2 страниц), Руководство пользователя (2 страниц), Технический справочник (30 страниц), Руководство по установке (19 страниц), Краткое справочное руководство (2 страниц), Руководство по установке (25 страниц), Декларация о соответствии (1 страниц), Руководство по печати (2 страниц), Дополнительное руководство (24 страниц), Руководство пользователя (6 страниц)

Mounting a GPS 17 Antenna

You can surface mount the GPS 17 antenna or install it on a standard 1 in. OD pipe-threaded-pole marine mount (14 threads per inch—not

included).

Surface Mounting the GPS 17 Antenna

1. Cut out the Surface Mount Drilling Template provided on page 23, and tape it on the selected mounting location.

2. Mark the center of each mounting hole with a center punch and a hammer. If you plan to run the cable through the mounting surface, mark

the center of the additional, larger hole indicated on the template.

3. Drill the mounting holes using a

in. (19 mm) drill bit.

4. If you are routing the cable through the mounting surface, feed it through the larger hole, and apply marine sealant to the outside exit area.

5. Align the GPS 17 over the mounting holes, and fasten it using M4 screws (not included). The mounting threads in the GPS 17 are 8.10 mm

deep. Use screws of a proper length for the mounting surface, which do not thread

into the GPS 17 deeper than 8 mm. Screws that thread deeper than 8 mm may

damage the case.

Mounting holes

Pole Mounting the GPS 17 Antenna

To attach the enclosed pole-mount adapter to the GPS 17:

1. Thread the cable though the pole-mount adapter.

2. Align the tab on the pole-mount adapter to the notch on the GPS 17.

3. Use the included screws to secure the pole-mount adapter to the base of the GPS 17.

Attaching the Pole-mount Adapter to the GPS 17

in. (4.5 mm) drill bit. If you plan to run the cable through the mounting surface, drill the larger hole using

Bottom of GPS 17 Antenna

When installing the GPS 17, you can run the power/data

cable through the mounting surface or outside of the unit. If

the power/data cable is run through the mounting surface,

seal the outside exit area with marine sealant.

Align Notch

GPSMAP 4000/5000 Series Installation Instructions

M4 screws

and washers