Fujitsu PRIMERGY TX120 S2 Дополнительное руководство по обслуживанию - Страница 23

Просмотреть онлайн или скачать pdf Дополнительное руководство по обслуживанию для Сервер Fujitsu PRIMERGY TX120 S2. Fujitsu PRIMERGY TX120 S2 38 страниц.

Печатать страницу

1. Replacing the Processor

Replacement routines

4.2

Replacing the front panel module

Figure 8: Removing the front panel module

Ê Open the server as described in the

Ê Remove the screw at the right side of the front panel (see

page

23).

Ê Push the front panel module carefully out of the housing about one centi-

meter using a screwdriver.

Ê Pull the front panel module out of the housing.

Ê Disconnect the front panel cable from the front panel module.

Ê Connect the front panel cable to the new front panel module.

Ê Push the front panel module into the housing. Be careful not to damage the

front panel cable.

Ê Fasten the front panel board with the screw.

Ê Route the front panel cable in the cable clamps again.

Ê Close the server and connect all power plugs (for a detailed description see

the Options Guide).

TX120 S2

Replacing the front panel module

section "Preparation" on page

Service Supplement

17.

figure 8 on