Fujitsu Primergy TX300 S4 Установка - Страница 3

Просмотреть онлайн или скачать pdf Установка для Сервер Fujitsu Primergy TX300 S4. Fujitsu Primergy TX300 S4 3 страницы. Pre-attached rack conversion kit
Также для Fujitsu Primergy TX300 S4: Руководство по конфигурированию системы и информации о заказах (17 страниц), Руководство по эксплуатации (8 страниц), Указания по использованию (4 страниц)

Connecting peripheral devices after installing the server

into the rack

Connect peripheral devices after installing the server into the rack. Use long enough cables because

you may pull the server from the rack when necessary.

n Fixing the power cable

To prevent the power cable from falling down, after connecting the power cable to the server, pass the supplied release tie

through the air holes and secure approximately 10 cm from the connector of the cable as seen in the figure below. When

unplugging the cable, make sure to unplug the connector on the server end.

��

Surely unplug the power connector at the server end when necessary.

n Cable forming process

After connecting the peripheral devices, tie all the cables and fix them with the release tie to the cable holder provided with

the rack. This forming process makes the cables easily recognizable even when multiple servers are installed in the rack.

��