Fujitsu FI-5900C Начало работы - Страница 24

Просмотреть онлайн или скачать pdf Начало работы для Сканер Fujitsu FI-5900C. Fujitsu FI-5900C 30 страниц. Consumable replacement and cleaning instructions
Также для Fujitsu FI-5900C: Начало работы (30 страниц), Руководство по процедурам установки (7 страниц), Руководство по процедурам установки (9 страниц), Процедуры установки (3 страниц), Брошюра и технические характеристики (2 страниц), Дополнительное руководство (4 страниц), Брошюра и технические характеристики (4 страниц), Инструкции по замене и очистке расходных материалов (24 страниц), Процедура замены (22 страниц), Инструкции по очистке (2 страниц)

Печатать страницу
Fujitsu FI-5900C Начало работы
Symptom
Paper is not fed (pick error
occurs frequently, or docu-
ment stops midway).
The generated images are
elongated.
There is a shadow on the
leading edge of the gener-
ated image.
2
AP-
Check this item
Do the documents satisfy the "Docu-
ment Quality" and the "Multifeed Detec-
tion Conditions" in the chapter 7 of the
fi-5900C Operator's Guide?
Are the Separator roller or the Pick roll-
ers dirty?
Are the Separator roller or the Pick roll-
ers worn out?
Is there any debris on the document feed
path?
Have you set the document thickness on
the Operator panel?
Are the Feed rollers or the Pinch rollers
dirty?
Have you adjusted the Vertical Magnifi-
cation?
Have you adjusted the offset (the scan-
ning starting position)?
Remedy
Use the documents that satisfy the "Document
Quality" and the "Multifeed Detection Condi-
tions" in chapter 7 of the fi-5900C Operator's
Guide.
Clean the Separator roller or the Pick rollers.
Refer to the fi-5900C Operator's Guide "4.
DAILY CARE".
Replace the Separator roller or the Pick rollers.
Refer to the fi-5900C Operator's Guide "5.
REPLACEMENT OF CONSUMABLES".
Remove any debris from the document feed path.
Set the document thickness thinner.
Clean the Feed rollers or the Pinch rollers. Refer
to the the fi-5900C Operator's Guide "4. DAILY
CARE".
Select "Scanners and Cameras" in the control
panel. Right-click on fi-5900C and select Proper-
ties. Click on the [Device Set] tab and then click
on the [Offset] button. Adjust the Vertical Mag-
nifcation.
Adjust the [Sub-scan Setting] on [Scanners and
Cameras] in the control panel.