Fujitsu FI-5900C 시작하기 - 페이지 24

{카테고리_이름} Fujitsu FI-5900C에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu FI-5900C 30 페이지. Consumable replacement and cleaning instructions
Fujitsu FI-5900C에 대해서도 마찬가지입니다: 시작하기 (30 페이지), 설치 절차 매뉴얼 (7 페이지), 설치 절차 매뉴얼 (9 페이지), 설치 절차 (3 페이지), 브로셔 및 사양 (2 페이지), 보충 설명서 (4 페이지), 브로셔 및 사양 (4 페이지), 소모품 교체 및 청소 지침 (24 페이지), 교체 절차 (22 페이지), 청소 지침 (2 페이지)

페이지 인쇄

Symptom

Paper is not fed (pick error

occurs frequently, or docu-

ment stops midway).

The generated images are

elongated.

There is a shadow on the

leading edge of the gener-

ated image.

AP-

Check this item

Do the documents satisfy the "Docu-

ment Quality" and the "Multifeed Detec-

tion Conditions" in the chapter 7 of the

fi-5900C Operator's Guide?

Are the Separator roller or the Pick roll-

ers dirty?

Are the Separator roller or the Pick roll-

ers worn out?

Is there any debris on the document feed

path?

Have you set the document thickness on

the Operator panel?

Are the Feed rollers or the Pinch rollers

dirty?

Have you adjusted the Vertical Magnifi-

cation?

Have you adjusted the offset (the scan-

ning starting position)?

Remedy

Use the documents that satisfy the "Document

Quality" and the "Multifeed Detection Condi-

tions" in chapter 7 of the fi-5900C Operator's

Guide.

Clean the Separator roller or the Pick rollers.

Refer to the fi-5900C Operator's Guide "4.

DAILY CARE".

Replace the Separator roller or the Pick rollers.

Refer to the fi-5900C Operator's Guide "5.

REPLACEMENT OF CONSUMABLES".

Remove any debris from the document feed path.

Set the document thickness thinner.

Clean the Feed rollers or the Pinch rollers. Refer

to the the fi-5900C Operator's Guide "4. DAILY

CARE".

Select "Scanners and Cameras" in the control

panel. Right-click on fi-5900C and select Proper-

ties. Click on the [Device Set] tab and then click

on the [Offset] button. Adjust the Vertical Mag-

nifcation.

Adjust the [Sub-scan Setting] on [Scanners and

Cameras] in the control panel.