Fujitsu ETERNUS DX Disk Руководство по конфигурации - Страница 28

Просмотреть онлайн или скачать pdf Руководство по конфигурации для Хранение Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 35 страниц. Server connection, fcoe for linux driver settings for converged network adapter cards
Также для Fujitsu ETERNUS DX Disk: Руководство пользователя (35 страниц), Руководство пользователя (42 страниц), Руководство по конфигурации (28 страниц), Руководство по конфигурации (44 страниц), Руководство по конфигурации (28 страниц), Руководство по конфигурации (29 страниц), Руководство по конфигурации (25 страниц), Руководство по конфигурации (32 страниц), Руководство по конфигурации (31 страниц), Руководство по конфигурации (43 страниц), Руководство по конфигурации (21 страниц), Руководство по конфигурации (24 страниц)

Печатать страницу
Fujitsu ETERNUS DX Disk Руководство по конфигурации
Chapter 2
Setup Procedure for QLogic Converged Network Adapter Cards
2.2
Setting Up the Converged Network Adapter Cards
8
Select [Reboot System] and press the [Enter] key.
The server reboots.
To return to the [Fast!UTIL] menu, select [Return to Fast!UTIL].
2.2.4

Installing VMware ESX

VMware ESX should be installed now if it has not yet been installed in the server. Refer to the following
•
URL for details.
http://www.vmware.com/support/pubs/
•
If SAN Boot is used, use the QLogic "Fast!UTIL" tool to check the Fibre Channel path in the Converged Net-
work Adapter card BIOS.
The Fibre Channel path can be checked on the server BIOS screen after the Fibre Channel switch and the
CEE/FCoE switch settings are completed.
The checking procedure is as follows:
1
Turn on the server, and press the [Ctrl] + [Q] keys while the following message is displayed.
The "Fast!UTIL" program starts up (Startup may take longer than usual).
QLE8142
Copyright (C) QLogic Corporation 1993-2010. All rights reserved.
www.qlogic.com
Press <CTRL-Q> or <ALT-Q> for Fast!UTIL
Firmware Version 5.04.01
2
When there are two or more FCoE ports for the Converged Network Adapter card, select the appropriate
port.
3
Select [Scan Fibre Devices] from the [Fast!UTIL Options] menu.
The ETERNUS DX storage systems should appear.
If the ETERNUS DX storage systems appear, the settings were performed successfully. If the ETERNUS DX stor-
age systems do not appear, recheck the setup procedures given in this manual, the ETERNUSmgr installation
and settings, or the Fibre Channel switch and CEE/FCoE switch settings.
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware
Exit Fast!UTIL
Reboot System
Return to Fast!UTIL
PCI Fibre Channel ROM BIOS Version 3.00 - Beta 14
Copyright 2015 FUJITSU LIMITED
28
®
ESX
P3AM-4772-11ENZ0