Fujitsu ETERNUS DX Disk Руководство по конфигурации - Страница 26

Chapter 2

Setup Procedure for QLogic Converged Network Adapter Cards

2.2

Setting Up the Converged Network Adapter Cards

(2)

Select the Converged Network Adapter card to be set (BIOS setting) in the [Select Host Adapter]

window.

The [Fast!UTIL Options] menu appears. Then perform

Select [Exit Fast!UTIL] and press the [Enter] key.

Select [Reboot System] and press the [Enter] key.

The server reboots.

To return to the [Fast!UTIL] menu, select [Return to Fast!UTIL].

2.2.2

Setting Up SAN Boot

Refer to "Server Support Matrix" to check the support status of SAN Boot and refer to the manual of the serv-

er, OS, or the Converged Network Adapter card that is to be used.

When using a logical unit (LUN) of the ETERNUS DX storage systems as a boot disk, make sure that the LUN

has enough capacity to install the OS.

2.2.3

Select [Selectable Boot Settings] from the [Configuration Settings] menu and press the [Enter] key.

Set [Selectable Boot] to "Enabled".

Select a boot path (ETERNUS DX port WWN) and boot LUN#.

The boot path and boot LUN# selection window only appears when [Host Adapter BIOS] is "Enabled"

in [SAN Boot].

If [Host Adapter BIOS] is "Disabled", the boot path and boot LUN# selection window does not appear.

Instead, the window shown in

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware

Exit Fast!UTIL

Reboot System

Return to Fast!UTIL

Step 4

Step 3

appears when [Selectable Boot Settings] is selected.

through

Step

10.

ESX

P3AM-4772-11ENZ0