Fujitsu ETERNUS DX Disk 구성 매뉴얼 - 페이지 26

{카테고리_이름} Fujitsu ETERNUS DX Disk에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX Disk 35 페이지. Server connection, fcoe for linux driver settings for converged network adapter cards
Fujitsu ETERNUS DX Disk에 대해서도 마찬가지입니다: 사용자 설명서 (35 페이지), 사용자 설명서 (42 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (44 페이지), 구성 매뉴얼 (28 페이지), 구성 매뉴얼 (29 페이지), 구성 매뉴얼 (25 페이지), 구성 매뉴얼 (32 페이지), 구성 매뉴얼 (31 페이지), 구성 매뉴얼 (43 페이지), 구성 매뉴얼 (21 페이지), 구성 매뉴얼 (24 페이지)

Chapter 2

Setup Procedure for QLogic Converged Network Adapter Cards

2.2

Setting Up the Converged Network Adapter Cards

(2)

Select the Converged Network Adapter card to be set (BIOS setting) in the [Select Host Adapter]

window.

The [Fast!UTIL Options] menu appears. Then perform

Select [Exit Fast!UTIL] and press the [Enter] key.

Select [Reboot System] and press the [Enter] key.

The server reboots.

To return to the [Fast!UTIL] menu, select [Return to Fast!UTIL].

2.2.2

Setting Up SAN Boot

Refer to "Server Support Matrix" to check the support status of SAN Boot and refer to the manual of the serv-

er, OS, or the Converged Network Adapter card that is to be used.

When using a logical unit (LUN) of the ETERNUS DX storage systems as a boot disk, make sure that the LUN

has enough capacity to install the OS.

2.2.3

Select [Selectable Boot Settings] from the [Configuration Settings] menu and press the [Enter] key.

Set [Selectable Boot] to "Enabled".

Select a boot path (ETERNUS DX port WWN) and boot LUN#.

The boot path and boot LUN# selection window only appears when [Host Adapter BIOS] is "Enabled"

in [SAN Boot].

If [Host Adapter BIOS] is "Disabled", the boot path and boot LUN# selection window does not appear.

Instead, the window shown in

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware

Exit Fast!UTIL

Reboot System

Return to Fast!UTIL

Step 4

Step 3

appears when [Selectable Boot Settings] is selected.

through

Step

10.

ESX

P3AM-4772-11ENZ0