Fujitsu ETERNUS DX Disk Yapılandırma Kılavuzu - Sayfa 26

Depolama Fujitsu ETERNUS DX Disk için çevrimiçi göz atın veya pdf Yapılandırma Kılavuzu indirin. Fujitsu ETERNUS DX Disk 35 sayfaları. Server connection, fcoe for linux driver settings for converged network adapter cards
Ayrıca Fujitsu ETERNUS DX Disk için: Kullanıcı Kılavuzu (35 sayfalar), Kullanıcı Kılavuzu (42 sayfalar), Yapılandırma Kılavuzu (28 sayfalar), Yapılandırma Kılavuzu (44 sayfalar), Yapılandırma Kılavuzu (28 sayfalar), Yapılandırma Kılavuzu (29 sayfalar), Yapılandırma Kılavuzu (25 sayfalar), Yapılandırma Kılavuzu (32 sayfalar), Yapılandırma Kılavuzu (31 sayfalar), Yapılandırma Kılavuzu (43 sayfalar), Yapılandırma Kılavuzu (21 sayfalar), Yapılandırma Kılavuzu (24 sayfalar)

Chapter 2

Setup Procedure for QLogic Converged Network Adapter Cards

2.2

Setting Up the Converged Network Adapter Cards

(2)

Select the Converged Network Adapter card to be set (BIOS setting) in the [Select Host Adapter]

window.

The [Fast!UTIL Options] menu appears. Then perform

Select [Exit Fast!UTIL] and press the [Enter] key.

Select [Reboot System] and press the [Enter] key.

The server reboots.

To return to the [Fast!UTIL] menu, select [Return to Fast!UTIL].

2.2.2

Setting Up SAN Boot

Refer to "Server Support Matrix" to check the support status of SAN Boot and refer to the manual of the serv-

er, OS, or the Converged Network Adapter card that is to be used.

When using a logical unit (LUN) of the ETERNUS DX storage systems as a boot disk, make sure that the LUN

has enough capacity to install the OS.

2.2.3

Select [Selectable Boot Settings] from the [Configuration Settings] menu and press the [Enter] key.

Set [Selectable Boot] to "Enabled".

Select a boot path (ETERNUS DX port WWN) and boot LUN#.

The boot path and boot LUN# selection window only appears when [Host Adapter BIOS] is "Enabled"

in [SAN Boot].

If [Host Adapter BIOS] is "Disabled", the boot path and boot LUN# selection window does not appear.

Instead, the window shown in

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware

Exit Fast!UTIL

Reboot System

Return to Fast!UTIL

Step 4

Step 3

appears when [Selectable Boot Settings] is selected.

through

Step

10.

ESX

P3AM-4772-11ENZ0