Aqua Comfort Vintage Classic Series Руководство пользователя - Страница 8

Просмотреть онлайн или скачать pdf Руководство пользователя для Нагреватель для плавательного бассейна Aqua Comfort Vintage Classic Series. Aqua Comfort Vintage Classic Series 14 страниц. Heat pump pool heaters

Печатать страницу

1. Troubleshooting Checklist

• When user lowers the set point below 50 degrees F in one of these modes, that mode will be

turned OFF.

NOTE: AN EXTERNAL SWITCH LOCATED ON FRONT OF THE CONTROL PANEL IS

USED TO TOGGLE BETWEEN HEAT AND COOL.

POOL MODE – HEATING

When operating in pool heat mode display will show POOL – HEAT on the top line and the actual

pool water temperature on the bottom line. FOR EXAMPLE:

• To adjust the temperature set point user will press either the Up or DOWN button once. The

Display will show "POOL TEMPERATURE" on the top line and the current set point

temperature on the bottom line for 5 seconds (for example: SETPOINT 95F). Adjust the set

point by pressing either UP or DOWN until the new set point is reached for heating.

• The display will revert to "POOL – HEAT" after 5 seconds of inactivity and the new set

point will be stored in memory.

• When the water temperature falls 1 degree below the set point, the control will energize

heating mode (compressor) after the time delay has expired. The time delay is necessary to

ensure proper water pressure within the pool filter system and to avoid short-cycling the

compressor.

• During heating once the water temperature reaches the set point, compressor is turned off.

POOL MODE – COOLING

When operating in pool cool mode the display will show POOL – COOL on the top line and the

actual pool water temperature on the second line. FOR EXAMPLE:

• An external switched located on the front of the control panel is used to toggle between heat

and cool. Control will switch to cool mode by closing the switch in which case display will

show POOL – COOL on the top line and the current temperature on the bottom line.

• To adjust the temperature point user will press either the UP or DOWN button once. The

display will show "POOL TEMPERATURE" on the top line and the current set point

temperature on the bottom line for 5 seconds. Adjust the set point by pressing either UP or

DOWN until the new set point is reached for cooling.

• The display will revert to "POOL – COOL" after 5 seconds of inactivity and the new set

point will be stored in memory.

• When the temperature becomes 1 degree greater than the set point, the control will energize

cooling mode (compressor and reversing valve)) after the time delay has expired.

• During cooling once the water temperature reaches the set point, the compressor is turned

off.

POOL – HEAT

95º

POOL – COOL

70º