Aqua Creek Scout 2 Руководство пользователя - Страница 7

Просмотреть онлайн или скачать pdf Руководство пользователя для Подъемные системы Aqua Creek Scout 2. Aqua Creek Scout 2 17 страниц. Pool lift

TOOLS REQUIRED:

1/2" WRENCH

9/16" WRENCH

3/4" WRENCH

Lift the Scout MAIN ASSEMBLY from the shipping container. Insert the 1.9" [48mm] post of the

MAIN ASSEMBLY into the deck anchor (FIGURE A, PAGE 5). Ease the MAIN ASSEMBLY down until

it rests on the deck surface. Rotate the base until the fi xing anchor-tab lines-up with the fi xing

anchor. Install the 1/2" x 2" hex bolt and washer to hold down the lift. Tighten the bolt.

Remove the shipping strap and all packing from the ACTUATOR. Connect the LIFTING ARM

between the mast and the ACTUATOR (FIGURE D). Tighten nylock nuts (PHOTO 1 & PHOTO 2).

PHOTO 1

PHOTO 3

NOTE: Be careful not to over-tighten bolts.

Over-tightening can cause damage and

compromise the safety of your lift.

Scout 2 Assembly Instructions

3/16" ALLEN WRENCH

1/4" ALLEN WRENCH

PHOTO 2

WARNING:

NEVER LIFT THE MAIN ASSEMBLY

USING THE LINEAR ACTUATOR AS A HANDLE! USE

AT LEAST TWO PEOPLE TO LIFT. USE A TRANSPORT

CART IF AVAILABLE.

3/8"-16 NYLOCK NUT

3/8" FLAT WASHER

SHOULDER BOLT

LINEAR

NOTE: The LIFTING ARM is easily fl ipped

around the wrong way. Make sure the end

marked "B" is towards the mast, as shown.

1/2" X 2 3/4"

('B' END: SEE NOTE)

5/16"-18 NYLOCK NUT

5/16" FLAT WASHER

3/8" X 2"

SHOULDER BOLT

SCOUT LIFTING ARM

(LONG END: SEE NOTE)

FIGURE D

Revised 6/8/18