Aqua Creek Scout 2 Руководство пользователя - Страница 8

Просмотреть онлайн или скачать pdf Руководство пользователя для Подъемные системы Aqua Creek Scout 2. Aqua Creek Scout 2 17 страниц. Pool lift

Scout 2 Assembly Instructions (cont.)

Install the CONTROL ARM ("A" END)

onto the mast as shown in FIGURE E.

Tighten the nylock nut (PHOTO 3, PAGE 7).

Install the CHAIR ARM at the ends of the

LIFTING ARM and CONTROL ARM (FIGURE E).

Tighten the nylock nuts (PHOTOS 4 & 5).

NOTE: Make sure the letters match up; with the

chair facing away from the main assembly.

NOTE: Flip the CONTROL ARM (upper arm) out

of the way while the LIFTING ARM (lower arm) is

attached first (this makes it easier to line-up the

holes).

Remove the fully charged BATTERY from the

charger and install the battery to the control

bracket, on top of the control box. Once secure,

connect the battery cable to the control box

cable. The lift will only operate when the battery is

connected properly.

WHEN LIFT IS NOT IN SERVICE, STORE BATTERY

ON THE CHARGER!

1/2" X 2-3/4" SHOULDER BOLT

FIGURE E

3/8"-16 NYLOCK NUT (2)

3/8" FLAT WASHER (2)

FIGURE F

PHOTO 4

3/8" FLAT WASHER

3/8"-16 NYLOCK NUT

"A" END

SCOUT CONTROL ARM

1/2" X 3" SHOULDER BOLT (2)

CHAIR-ARM ASSEMBLY

PHOTO 5

Revised 6/8/18