Aqua Creek F-044SCH-04 Руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Зарядное устройство Aqua Creek F-044SCH-04. Aqua Creek F-044SCH-04 9 страниц. 24v solar charger for use with admiral, ranger 2, ambassador
AMBASSADOR LIFT
REMOVE THIS
1/2" HEX BOLT
To install the Solar Charger on a Ambassador lift;
STEP 1: Remove the 1/2" hex bolt from the back anchor insert as shown above.
STEP 2: Place the 24V Solar Charger over the base frame where the bolt was removed.
STEP 3: Align the mounting stud with the base frame & anchor insert. Thread the mounting stud into the
anchor insert and tighten. Use a 1" wrench to make sure it is snug.
STEP 4: Run the BATTERY CABLE along the base frame, back under the main frame, and up the actuator
frame as shown. See page 5 for instructions on plugging the system into the control box.
Copyright © 2020 Aqua Creek Products All Rights Reserved
Ambassador Installation
NOTE: MAKE SURE TO RUN
BATTERY CABLE ALONG
BASE & MAIN FRAMES
AS SHOWN TO CABLE GOES
UP & DOWN WITH THE LIFT
MAIN FRAME
BASE FRAME
BATTERY CABLE RUNS
ALONG BASE FRAME,
BACK UNDER MAIN FRAME
& UP THE ACTUATOR FRAME
BATTERY
ACTUATOR
FRAME
CONTROL BOX
CHARGE
CONNECTOR
PLUGS INTO
CONTROL BOX
THREAD INTO
ANCHOR INSERT
TIGHTEN WITH
1" WRENCH
3
Revised 3/18/20