Aqua Creek F-044SCH-04 Petunjuk Manual - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Pengisi Daya Baterai Aqua Creek F-044SCH-04. Aqua Creek F-044SCH-04 9 halaman. 24v solar charger for use with admiral, ranger 2, ambassador

Halaman Cetak

AMBASSADOR LIFT

REMOVE THIS

1/2" HEX BOLT

To install the Solar Charger on a Ambassador lift;

STEP 1: Remove the 1/2" hex bolt from the back anchor insert as shown above.

STEP 2: Place the 24V Solar Charger over the base frame where the bolt was removed.

STEP 3: Align the mounting stud with the base frame & anchor insert. Thread the mounting stud into the

anchor insert and tighten. Use a 1" wrench to make sure it is snug.

STEP 4: Run the BATTERY CABLE along the base frame, back under the main frame, and up the actuator

frame as shown. See page 5 for instructions on plugging the system into the control box.

Ambassador Installation

NOTE: MAKE SURE TO RUN

BATTERY CABLE ALONG

BASE & MAIN FRAMES

AS SHOWN TO CABLE GOES

UP & DOWN WITH THE LIFT

MAIN FRAME

BASE FRAME

BATTERY CABLE RUNS

ALONG BASE FRAME,

BACK UNDER MAIN FRAME

& UP THE ACTUATOR FRAME

BATTERY

ACTUATOR

FRAME

CONTROL BOX

CHARGE

CONNECTOR

PLUGS INTO

CONTROL BOX

THREAD INTO

ANCHOR INSERT

TIGHTEN WITH

1" WRENCH

Revised 3/18/20