Aqua Free AS DataLog Инструкции по эксплуатации и установке - Страница 4

Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и установке для Измерительные приборы Aqua Free AS DataLog. Aqua Free AS DataLog 5 страниц.

Печатать страницу

NOTE!

Store the loose components of the FLUSH 2.0

system in the enclosed case. You will need them

again if the flushing system is to be used without the

recording unit.

■

Re-fit the FLUSH 2.0 system to the appropriate tap

adaptor.

CAUTION!

Please also refer to the operating instructions for the

FLUSH 2.0 system

7.2 Software

The "AS DataLog" software is required for programming the

AS DataLog and evaluating the data recorded. The files and

respective instructions can be found on the device in the

"Software" folder.

Troubleshooting

It is possible that the "AS DataLog" system may not start

correctly or is not recognised as a Windows drive. In this

case, it is necessary to reset the system.

Please proceed as follows:

1. Remove the lid of the battery compartment.

2. Briefly press the "RESET" button.

LED status signal

The "AS DataLog" recording system indicates the device

status via an integrated LED.

LED

LED off

LED flashes 4 times at

intervals of 2 sec.

LED flashes once at

intervals of 30 sec.

Status

1. Battery flat; battery

needs to be changed

2. New battery inserted

but no data recording

programmed yet

2 s

The "AS DataLog"

system is connected to

a PC; no measurements

are being recorded. As

soon as the "Setup"

option is clicked in the

evaluation software, the

LED goes off.

30 s

Data recording is active

(data is saved every 30

seconds); no measure

required.