Base I/O Address If port is set to Enabled, available I/O addresses are 3F8, 3E8, 2F8, and 2E8.
Interrupt
Parallel port
Configures the parallel port. Set this option to Auto (default), Enabled, or Disabled. Depending on the port setting, you can
set the following additional options:
Mode
NOTE: Before changing this setting, refer to the device manufacturer's documentation for information on
which mode to use.
Base I/O
Address
Interrupt
Legacy USB
Set to Disabled if legacy USB support is not desired. Auto (default) and Enabled allow support for legacy USB.
Support
IRQ5
Reserved (default) indicates that the IRQ is reserved for use by legacy devices. Available indicates that a specific IRQ is
available on the computer.
IDE Configuration Submenu
Table 5. IDE Configuration Submenu Options
Option
Function
IDE
Configures the integrated primary and secondary IDE controllers and detects the types of drives attached to them. If set to
Controller
Primary, Secondary, or Both, the designated controller(s) are enabled, and the types of drives attached are displayed. If set to
either Primary or Secondary, the other controller is not enabled and the IRQ it normally uses becomes available. If set to
Disabled, the computer cannot detect any drives attached to the controllers and displays None for all four IDE drive options.
Primary IDE
Identifies the first drive attached to the primary IDE interface, usually the boot hard drive. See
Master
Primary IDE
Identifies the second drive attached to the primary IDE interface, usually a second hard drive. The format of this submenu is the
Slave
same as the one described in
Secondary
Identifies the first drive attached to the secondary IDE interface, if there is one. The format of this submenu is the same as the
IDE Master
one described in
Secondary
Identifies the second drive attached to the secondary IDE interface, usually a CD or tape drive. The format of this submenu is the
IDE Slave
same as the one described in
Primary IDE Master Submenu
If port is set to Enabled, available interrupts are IRQ3 and IRQ4.
If port is set to Auto or Enabled, available modes are Output Only, Bi-directional, ECP
(default), and EPP.
If port is set to Enabled, available I/O addresses are 378 (default), 278, and 228.
If port is set to Enabled, available interrupts are 7 and 5.
"Primary IDE Master
"Primary IDE Master
Submenu."
"Primary IDE Master
Submenu"
Submenu"
"Primary IDE Master
Submenu."
Печатать страницу