Dell Inspiron 2100 시스템 참조 매뉴얼 - 페이지 34

{카테고리_이름} Dell Inspiron 2100에 대한 시스템 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Inspiron 2100 45 페이지. Vga card installation instructions
Dell Inspiron 2100에 대해서도 마찬가지입니다: 여기에서 시작 (2 페이지), 설정 및 기능 정보 (8 페이지), 빠른 참조 매뉴얼 (17 페이지), 서비스 매뉴얼 (38 페이지), 사양 (2 페이지), 설치 지침 (1 페이지)

페이지 인쇄

Base I/O Address If port is set to Enabled, available I/O addresses are 3F8, 3E8, 2F8, and 2E8.

Interrupt

Parallel port

Configures the parallel port. Set this option to Auto (default), Enabled, or Disabled. Depending on the port setting, you can

set the following additional options:

Mode

NOTE: Before changing this setting, refer to the device manufacturer's documentation for information on

which mode to use.

Base I/O

Address

Interrupt

Legacy USB

Set to Disabled if legacy USB support is not desired. Auto (default) and Enabled allow support for legacy USB.

Support

IRQ5

Reserved (default) indicates that the IRQ is reserved for use by legacy devices. Available indicates that a specific IRQ is

available on the computer.

IDE Configuration Submenu

Table 5. IDE Configuration Submenu Options

Option

Function

IDE

Configures the integrated primary and secondary IDE controllers and detects the types of drives attached to them. If set to

Controller

Primary, Secondary, or Both, the designated controller(s) are enabled, and the types of drives attached are displayed. If set to

either Primary or Secondary, the other controller is not enabled and the IRQ it normally uses becomes available. If set to

Disabled, the computer cannot detect any drives attached to the controllers and displays None for all four IDE drive options.

Primary IDE

Identifies the first drive attached to the primary IDE interface, usually the boot hard drive. See

Master

Primary IDE

Identifies the second drive attached to the primary IDE interface, usually a second hard drive. The format of this submenu is the

Slave

same as the one described in

Secondary

Identifies the first drive attached to the secondary IDE interface, if there is one. The format of this submenu is the same as the

IDE Master

one described in

Secondary

Identifies the second drive attached to the secondary IDE interface, usually a CD or tape drive. The format of this submenu is the

IDE Slave

same as the one described in

Primary IDE Master Submenu

If port is set to Enabled, available interrupts are IRQ3 and IRQ4.

If port is set to Auto or Enabled, available modes are Output Only, Bi-directional, ECP

(default), and EPP.

If port is set to Enabled, available I/O addresses are 378 (default), 278, and 228.

If port is set to Enabled, available interrupts are 7 and 5.

"Primary IDE Master

Submenu."

"Primary IDE Master

Submenu"

"Primary IDE Master

Submenu."