Allied Telesis AR400 Series Руководство по быстрой установке - Страница 5

Просмотреть онлайн или скачать pdf Руководство по быстрой установке для Сетевое оборудование Allied Telesis AR400 Series. Allied Telesis AR400 Series 12 страниц. How to set up pppoe between a linux client and access concentrator
Также для Allied Telesis AR400 Series: Как настроить (6 страниц), Руководство по устранению неполадок (8 страниц), Устранение неполадок (5 страниц), Руководство по быстрой установке (8 страниц), Руководство по технике безопасности (18 страниц), Как сделать (8 страниц)

Печатать страницу
Allied Telesis AR400 Series Руководство по быстрой установке
Quick Install Guide
C613-04032-01 REV E
•
Screw the handles to the wider side of each bracket, using the supplied
M3 screws (see Figure 1)
•
Screw the brackets to the sides of the router, using the supplied M3
screws (see Figure 1). The router can be front or rear mounted
Figure 1: Connecting the rack mount bracket to the router.
•
Mount the router in the rack using appropriate rack mounting screws
(not supplied)
5.
Install expansion options (AR410 and AR410S routers).
If you purchased an optional PIC, install it now by following the PIC Quick
Install Guide. That guide can be found on the Documentation and Tools
CD-ROM or can be downloaded from
www.alliedtelesyn.co.nz/support/ar400/.
6.
Check the supply voltage and the router's rated voltage.
AR400 Series routers are fitted with a universal mains power supply that
will function over the range 100-240 VAC and 50–60Hz.
The specific power supply requirements for a particular model are clearly
displayed on the rear or underside of the router. If the supply is outside the
accepted range for the router, the router may not operate or damage to the router
may result.
7.
Apply power to the router.
Fit the power cord retaining clip to the AC power inlet on the router's rear
panel.
Connect the provided power cord to the AC power inlet and clip it in
place. Switch the router's power switch to the ON position. The Power
LED will light continuously and the System LED will flash briefly. The Port
LEDs may also light briefly.
If the LEDs fail to light, the most likely cause is that the router is not
receiving power. Check that
•
The power supply outlet's switch (if any), and the router's power
switch, are in the ON position
5