Dell PowerEdge 4600 Руководство - Страница 13

Просмотреть онлайн или скачать pdf Руководство для Сервер Dell PowerEdge 4600. Dell PowerEdge 4600 19 страниц. Poweredge 4600
Также для Dell PowerEdge 4600: Обновление информации (14 страниц), Руководство по обновлению (42 страниц), Руководство (48 страниц), Руководство по установке (42 страниц), Руководство по удалению (28 страниц), Руководство по установке (28 страниц), Руководство (15 страниц), Технические характеристики (2 страниц)

Installing the Trim Panel

To install the tower trim panel on the chassis, perform the following steps.

NOTE: You may find it convenient to leave the chassis in the rack position (as shown

NOTICE: You will need two to four persons to lift the system into position above the

1-10

Rac k - t o-To we r Co n v ers io n G ui d e

Lay the front panel on a smooth work surface with the outside surface facing

down.

Remove the two 6-32 x 0.25-inch hex-head Phillips screws that secure the control

panel board to the back of the front panel.

Set the control panel and screws aside for installation on the tower front panel.

in Figure 1-6) while installing the trim panel.

Hold the tower trim panel in position with the sides facing up as shown in Figure 1-6.

trim panel. One additional person may be needed to separate the trim panel from

chassis obstructions.

Using two or four persons, lift the system chassis.

Lower the system chassis into the trim panel (see Figure 1-6).

After the chassis is lowered into place, align the three holes in the trim panel with the

three holes in the chassis.

Secure the right side of the trim panel with three 6-32 x 0.25-inch hex-head Phillips

screws (see Figure 1-6).

Secure the back of the trim panel with three 6-32 x 0.25-inch hex-head Phillips screws.