Dell PowerEdge 860 Руководство по установке - Страница 2

Просмотреть онлайн или скачать pdf Руководство по установке для Сервер Dell PowerEdge 860. Dell PowerEdge 860 28 страниц. Sas/raid controller installation
Также для Dell PowerEdge 860: Обновление информации (14 страниц), Руководство по установке (7 страниц), Руководство по эксплуатации (37 страниц)

Dell PowerEdge 860 Руководство по установке
Insert the card-edge connector firmly into the system-board card connector until the card
b
is fully seated.
NOTE:
Some systems use a plastic bar to secure the expansion-card bracket to the back panel
instead of a screw.
Install the screw that secures the expansion-card bracket to the back panel.
c
6
Close the system. See "Closing the System" in the Installation and Troubleshooting Guide for
instructions.
Figure 1. Installing the DRAC 4/P Card
DRAC 4/P card
card-interface
connector
interface cable
RAC connector
7
Connect the monitor cable to the card video connector on the DRAC 4/P card. See Figure 2.
The monitor cable must be connected to the card video connector on the DRAC 4/P card—
not to the system's integrated video connector.
8
Connect the network to the card NIC connector on the DRAC 4/P card. See Figure 2.
The network cable must be connected to the card NIC connector on the DRAC 4/P card—
not to the system's integrated NIC connector.
9
Reattach the system to its AC power source and turn on the system.
expansion-card bracket
The connectors on your system board and the actual
expansion slot that you use may vary on your system board.
screw
card-edge
connector
system-
board card
connector
expansion
slot