Dell PowerEdge 860 Kurulum Kılavuzu - Sayfa 2
Sunucu Dell PowerEdge 860 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dell PowerEdge 860 28 sayfaları. Sas/raid controller installation
Ayrıca Dell PowerEdge 860 için: Bilgi Güncellemesi (14 sayfalar), Kurulum Talimatları Kılavuzu (7 sayfalar), Servis Kılavuzu (37 sayfalar)
Insert the card-edge connector firmly into the system-board card connector until the card
b
is fully seated.
NOTE:
Some systems use a plastic bar to secure the expansion-card bracket to the back panel
instead of a screw.
Install the screw that secures the expansion-card bracket to the back panel.
c
6
Close the system. See "Closing the System" in the Installation and Troubleshooting Guide for
instructions.
Figure 1. Installing the DRAC 4/P Card
DRAC 4/P card
card-interface
connector
interface cable
RAC connector
7
Connect the monitor cable to the card video connector on the DRAC 4/P card. See Figure 2.
The monitor cable must be connected to the card video connector on the DRAC 4/P card—
not to the system's integrated video connector.
8
Connect the network to the card NIC connector on the DRAC 4/P card. See Figure 2.
The network cable must be connected to the card NIC connector on the DRAC 4/P card—
not to the system's integrated NIC connector.
9
Reattach the system to its AC power source and turn on the system.
expansion-card bracket
The connectors on your system board and the actual
expansion slot that you use may vary on your system board.
screw
card-edge
connector
system-
board card
connector
expansion
slot