Dell PowerEdge R620 Руководство по установке, обслуживанию и устранению неисправностей - Страница 40

Просмотреть онлайн или скачать pdf Руководство по установке, обслуживанию и устранению неисправностей для Сервер Dell PowerEdge R620. Dell PowerEdge R620 48 страниц. Poweredge series
Также для Dell PowerEdge R620: Руководство (11 страниц), Руководство по началу работы (12 страниц), Инструкции по установке (2 страниц), Инструкции по установке (2 страниц), Руководство по портфолио (27 страниц), Руководство по началу работы (10 страниц)

Chapter 3: Maintenance

●

●

Connecting the switch link

The CMS computer uses TCP/IP over a local area network (LAN) at only 10/100 Mbps for a

connection to the switch. One CMS computer can collect data from several switches. To the

CMS computer, each switch represents one ACD.

You must use ethernet port 1 for this connection.

For detailed information about how to connect and administer the switch link, see Avaya Call

Management System Switch Connections, Administration, and Troubleshooting.

Connecting to the customer network

The computer supports built-in ethernet ports that support network speeds of 10/100/1000

Mbps. However, for CMS installations, Avaya recommends that you only use speeds at the 10/

100 Mbps speed range. This ethernet connection is used for CMS Supervisor, network printers,

and LAN backup.

You must use ethernet port 0 for this connection.

Connecting the tape drive

Connections to the tape drive are for the Dell R720 and Dell R620 platform only.

A Serial Attached SCSI (SAS) cable connects from the SAS port located on the back of the

computer to the SAS port on the back of the tape drive.

To turn on the system:

1. Connect the power cord from the tape drive to a power source.

2. Turn on the tape drives, starting with the tape drive that is farthest from the system and

working toward the system.

3. Turn on the system monitor.

Avaya CMS Dell R720 and R620 Computer Hardware Installation

on page 40.

October 2015