Dell EqualLogic PS Series Руководство пользователя аппаратного обеспечения - Страница 27
Просмотреть онлайн или скачать pdf Руководство пользователя аппаратного обеспечения для Хранение Dell EqualLogic PS Series. Dell EqualLogic PS Series 50 страниц. Storage arrays
Также для Dell EqualLogic PS Series: Настройка (2 страниц), Руководство пользователя аппаратного обеспечения (48 страниц), Обслуживание оборудования (46 страниц)
Печатать страницу
PS6610 Hardware Owner's Manual
Using the Standby On/Off button on one member does not affect any other group members, with the
exception of the group lead member. When the group lead member is in standby mode, it takes a few
minutes for the group lead to fail over to another member. You must press the standby button on each
member to restore power to the member that is in standby mode. Group members that do not have the
standby button remain online; to shut them down, you must use the GUI or CLI.
Replace a Control Module
If a control module fails, remove it and replace it with a functioning control module, as described in
this section.
You will need to swap the battery from the old to the new control module before inserting the
replacement control module.
You will also need to temporarily remove a control module when you want to replace its microSD card.
Refer to
Replace the MicroSD Card on page 25
You can partially or completely remove a control module without shutting down the array if the
remaining control module has at least one connected and functioning network interface. The procedures
for doing this type of control module replacement are described in
Procedures on page
21.
When you remove a control module, wear an electrostatic wrist strap, as described in
Protection on page
6, and be sure to place it on a surface that is protected from electrostatic discharge.
Control Module Replacement Procedures
This section describes the procedures for removing and replacing one or both control modules in your
PS Series array. The following replacement scenarios are covered:
• Replacing the secondary control module in an array
• Replacing the active control module in an array
• Replacing both control modules in an array
Replacing the Secondary Control Module
If the array is fully powered up and functioning, use the following procedure to replace the secondary
control module in the array:
1. Remove the control module from the array, as described in
2. Remove the SD card from the control module, as described in
25.
3. Install the SD card in the replacement control module, as described in
page
26.
4. Remove and swap the battery from the existing control module to the replacement control module,
as described in
Battery Replacement on page
5. Insert the replacement control module into the array, as described in
page
23.
Replacing the Active Control Module
Use the following procedure to replace the active control module in the array:
3 Control Module Maintenance
for information about replacing the microSD card.
Control Module Replacement
Remove a Control Module on page
Remove the MicroSD Card on page
27.
Hardware
Insert the MicroSD Card on
Install a Control Module on
22.
21