EarthWay 2170 Инструкция по сборке Руководство - Страница 3

Просмотреть онлайн или скачать pdf Инструкция по сборке Руководство для Разбрасыватель EarthWay 2170. EarthWay 2170 12 страниц. Commercial broadcast spreader with side spread control
Также для EarthWay 2170: Руководство по сборке и эксплуатации (6 страниц), Руководство по сборке и эксплуатации (8 страниц), Руководство по эксплуатации (8 страниц), Руководство по сборке и эксплуатации (6 страниц), Инструкция по сборке Руководство (10 страниц)

Assembly and Operation Instructions

Install impeller onto pinion shaft by pressing

Step 3:

the impeller as shown onto the pinion shaft and turning

the impeller while holding the pinion shaft to engage

with the COIN fully. Press down to secure.

Next, insert Cross Brace thru the Gearbox Brace as

shown.

Install gearbox by inserting the pinion shaft into

Step 4:

hole in center of hoppers bottom.

The word "FRONT" on the GEARBOX must point to Front

of the HOPPER. The EarthWay logo is on the front of the

hopper.

(A) Install lower handles onto the frame to

Step 5:

both sides as shown. Insert 2¼" bolt through second hole

in lower handle and through first hole in frame and install

locknut. DO NOT TIGHTEN.

(B) Now insert 1½" bolt through first hole in lower

handle. Then through frame brace. Next into threaded

connector in cross brace. DO NOT TIGHTEN.

NOTE: Numbers on frame brace must be facing toward

gear box as shown.

and through second hole in frame install locknut.

Install the axle through the axle hole in the

Step 6:

lower handle and then through the gearbox and then

through the lower handle on the other side as shown.

P2170_M52164_Rev_May2020_compressed

PAGE 3