EarthWay EV-N-Spred C22HDS Руководство по сборке и эксплуатации
Просмотреть онлайн или скачать pdf Руководство по сборке и эксплуатации для Разбрасыватель EarthWay EV-N-Spred C22HDS. EarthWay EV-N-Spred C22HDS 8 страниц. Broadcast spreader
Также для EarthWay EV-N-Spred C22HDS: Руководство по сборке и эксплуатации (6 страниц), Руководство по сборке и эксплуатации (6 страниц)
Печатать страницу
C22HD & C22HDS B
ASSEMBLY and OPERATING INSTRUCTIONS
PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS
REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
SUPPORT HOT LINE: 574-848-7491 or 800-294-0671, email: [email protected]
HELPFUL HINTS:
; If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The impeller must
turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller after each use as some
fertilizer may become stuck on the impeller blades and will cause uneven spreading.
; Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds will change
the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your spreader thoroughly after each
use. To prevent rust, please coat all metal surfaces, also inside tubes where possible, with a light oil or WD-40. Wash between the shut
off plate and bottom of the hopper.
; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
; If you use Rock Salt remove the agitator to prevent damage to the gearbox and remove salt from the hopper daily. Rock Salt will
reconstitute back into a solid block over night and will damage your spreader.
IF YOUR SPREADER COMES SEMI ASSEMBLED, SKIP TO STEP #6
Upper Handle
Gauge & Lever
Handle
Shaft
Frame
Impeller
Brace
Pivot
Rod
Frame
1. Remove and identify all of the loose parts from carton.
2. Position hopper on side. Install
frame using (4) #14 x 1½" Flat
Head Phillips screws. TIGHTEN
THESE NOW.
MADE IN THE USA
roadcast
Cross
Brace
Control
Rod
Lower
Handles
Pivot
Gearbox
Axle
(Qty 4) #31104
#14 X 1½"
Flat Head Screw
s
preader
WARNING
Do not use air tools to assemble. To prevent seizing,
spray all nuts & bolts with oil, grease, wax, or other
lubricant.
Gauge Overlay is snapped over the
metal gauge. Replace the stop bolt
assembly to secure overlay on the
gauge.
ROCK SALT and POWDERED
MATERIALS should not be used in this
spreader as it will damage gearbox and can
void warranty.
Use only granular materials.
36305
36300
Qty 2
Qty 17
31104
Qty 4
36200
Qty 4
36209
Qty 4
36205
Qty 3
33117
Qty 1
For
36404
C24HD
Qty 18
Only
36105
36104
Qty 1
Qty 1
36103
Qty 1
36207
Qty 2
6-2014 Pt# 52153
PAGE 1