EarthWay EV-N-Spred C22HDS Руководство по сборке и эксплуатации - Страница 2
Просмотреть онлайн или скачать pdf Руководство по сборке и эксплуатации для Разбрасыватель EarthWay EV-N-Spred C22HDS. EarthWay EV-N-Spred C22HDS 8 страниц. Broadcast spreader
Также для EarthWay EV-N-Spred C22HDS: Руководство по сборке и эксплуатации (6 страниц), Руководство по сборке и эксплуатации (6 страниц)
Печатать страницу
GEARBOX & AXLE ASSEMBLY
Cross Brace
COAST WHEEL
HOLE
3. Install impeller onto pinion shaft. Insert 1/8" x 1¼" cotter pin
through impeller then through pinion shaft. Use hole nearest gear box.
Spread cotter pin to prevent from falling out. Next, install the Cross
Brace through the Gearbox Brace Support as shown above.
Lower Handle
Frame Brace
Cross Brace
5. Install Lower Handles onto Axle to both sides as
shown above.
A. Now insert 2¼" bolt through second hole in lower
handle and through first hole in frame and secure with
locknut.
DO NOT TIGHTEN YET.
B. Now insert 1½" bolt through first hole in lower
handle, then through frame brace, and finally into
the threaded connector in the Cross Brace. [NOTE:
Numbers on frame braces must be facing toward
gearbox as shown.]
C. Next insert 1½" bolt through other end of frame brace
and through second hole in frame install locknut.
DO NOT TIGHTEN YET.
PAGE 2
Pinion
Shaft
Impeller
Cotter Pin (#36105)
Gearbox Brace
DRIVE WHEEL
HOLE
Gearbox
Axle Assembly
1/8 x 1-1/4"
4. Install Gearbox by inserting the pinion shaft into hole in center of
hoppers bottom. The word "FRONT" on the gearbox must point to
FRONT of the hopper.
Gearbox & Axle Assembly
COAST WHEEL SIDE
¼-20 x 1½"
Hex Head Bolt
and cupped washer
Step 5B
Step 5C
Frame brace
¼-20 x 2¼"
Hex Head Bolt
and cupped washer
Step 5A
~~N
c22Hd
otice
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS
STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN.
Gearbox
DRIVE WHEEL SIDE
Numbers
Cross Brace
Impeller
Shut-Off
¼-20 Lock nut
and cupped washer
Pivot Rod
cupped wasHer locatioNs
FRONT
Frame
¼-20 x 1½"
Hex Head Bolt
#14 x 1½"
Flat Head Screw
Lower Handle
~~