Allmatic B.RO X40 DISPLAY Руководство - Страница 2

Просмотреть онлайн или скачать pdf Руководство для Приемник Allmatic B.RO X40 DISPLAY. Allmatic B.RO X40 DISPLAY 20 страниц. 4 channels rolling code receiver, with display

Печатать страницу

REMARKS

Please read this instruction manual very carefully before installing and programming your control unit.

After the installation keep this instruction in a safe place for any further consultation.

• The device must not be used by people (children included), whose physical, sensory and mental capacities are reduced, or without

experience or knowledge, unless they could beneﬁ t through the intermediation of a person responsible for their safety, of a

surveillance or of instructions related to the use of the device.

• Children must be kept under surveillance to make sure that they do not play with the device.

• If the power supply's cable is damaged, it must be replaced by the manufacturer or by his assistance service or in any case by a

person with similar status in order to prevent any risk.

• This instruction manual is only for qualiﬁ ed technicians, who specialize in installations and automations.

• The contents of this instruction manual do not concern the ﬁ nal user.

• Every programming and/or every maintenance service should be done only by qualiﬁ ed technicians.

• The installer must provide the installation of a device (es. magnetothermical switch) that ensures the omnipolar sectioning of the

equipment from the power supply.

DESCRIPTION

B.RO X40 Display is a 4-channels Rolling Code receiver compatible with all Allmatic Rolling Code remotes. This device has an easy

and intuitive functioning thanks to the display interface and 3 buttons. 4 relay outputs are available with dry contact normally open

(N.O.) and/or closed (N.C.). Outputs can work with 4 different modes: dead man, step by step, timed and timed with delay. Each

output can be controlled by a dedicated wired input or by a single key of a memorized transmitter. The output function is directly

associated to the input command and no to the relay.

The learning of a key of a transmitter can be realized with 3 procedures: default learning (customizable), sequential and advanced.

Power supply 12-24 Vdc/Vac with automatic selection of the voltage.

ELECTRICAL CONNECTIONS

CONNECTIONS

1-5:

wired input (N.O. contact) for relay 1.

2-5:

wired input (N.O. contact) for relay 2.

3-5:

wired input (N.O. contact) for relay 3.

4-5:

wired input (N.O. contact) for relay 4.

6-7:

power supply.

8-9:

relay output 1 (N.O. contact).

9-10:

relay output 1 (N.C. contact).

11-12: relay output 2 (N.O. contact).

2/20

DISPLAY

20 21

DOWN

INPUTS LED

ITA

ENG

FRA

RADIO MODULE

MEMORY

OUTPUTS LED

OUT1

OUT2

OUT3

9 10 11 12 13 14 15 16 17 18 19

12-13: relay output 2 (N.C. contact).

14-15: relay output 3 (N.O. contact).

15-16: relay output 3 (N.C. contact).

17-18: relay output 4 (N.O. contact).

18-19: relay output 4 (N.C. contact).

20:

antenna braiding.

21:

antenna.

ESP

DEU

POR

OUT4

6-1620020

rev.0

27/10/2015