Allmatic B.RO X40 DISPLAY Manuel - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Allmatic B.RO X40 DISPLAY. Allmatic B.RO X40 DISPLAY 20 pages. 4 channels rolling code receiver, with display

Imprimer la page

REMARKS

Please read this instruction manual very carefully before installing and programming your control unit.

After the installation keep this instruction in a safe place for any further consultation.

• The device must not be used by people (children included), whose physical, sensory and mental capacities are reduced, or without

experience or knowledge, unless they could beneﬁ t through the intermediation of a person responsible for their safety, of a

surveillance or of instructions related to the use of the device.

• Children must be kept under surveillance to make sure that they do not play with the device.

• If the power supply's cable is damaged, it must be replaced by the manufacturer or by his assistance service or in any case by a

person with similar status in order to prevent any risk.

• This instruction manual is only for qualiﬁ ed technicians, who specialize in installations and automations.

• The contents of this instruction manual do not concern the ﬁ nal user.

• Every programming and/or every maintenance service should be done only by qualiﬁ ed technicians.

• The installer must provide the installation of a device (es. magnetothermical switch) that ensures the omnipolar sectioning of the

equipment from the power supply.

DESCRIPTION

B.RO X40 Display is a 4-channels Rolling Code receiver compatible with all Allmatic Rolling Code remotes. This device has an easy

and intuitive functioning thanks to the display interface and 3 buttons. 4 relay outputs are available with dry contact normally open

(N.O.) and/or closed (N.C.). Outputs can work with 4 different modes: dead man, step by step, timed and timed with delay. Each

output can be controlled by a dedicated wired input or by a single key of a memorized transmitter. The output function is directly

associated to the input command and no to the relay.

The learning of a key of a transmitter can be realized with 3 procedures: default learning (customizable), sequential and advanced.

Power supply 12-24 Vdc/Vac with automatic selection of the voltage.

ELECTRICAL CONNECTIONS

CONNECTIONS

1-5:

wired input (N.O. contact) for relay 1.

2-5:

wired input (N.O. contact) for relay 2.

3-5:

wired input (N.O. contact) for relay 3.

4-5:

wired input (N.O. contact) for relay 4.

6-7:

power supply.

8-9:

relay output 1 (N.O. contact).

9-10:

relay output 1 (N.C. contact).

11-12: relay output 2 (N.O. contact).

2/20

DISPLAY

20 21

DOWN

INPUTS LED

ITA

ENG

FRA

RADIO MODULE

MEMORY

OUTPUTS LED

OUT1

OUT2

OUT3

9 10 11 12 13 14 15 16 17 18 19

12-13: relay output 2 (N.C. contact).

14-15: relay output 3 (N.O. contact).

15-16: relay output 3 (N.C. contact).

17-18: relay output 4 (N.O. contact).

18-19: relay output 4 (N.C. contact).

20:

antenna braiding.

21:

antenna.

ESP

DEU

POR

OUT4

6-1620020

rev.0

27/10/2015