Miller 1055 Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Аксессуары для фотоаппаратов Miller 1055. Miller 1055 17 страниц. Fluid head

Miller 1055 Руководство по эксплуатации
Operating Instructions
The operating instructions are described in six steps. Please
read and understand these instructions before using this
equipment. Do not omit any steps.
The Cineline 70 Fluid Head can be mounted on a 150mm
TRIPOD BOWL or on a MITCHELL BASE.
1 Fluid Head Set-up (Mitchell Base)
1.1 Loosen the PAN HANDLE CLAMP fully then rotate the
PAN HANDLE until it is approximately perpendicular to the
THREADED STUD (fig. 1) and tighten the PAN HANDLE
CLAMP - avoid contact wear between the serrations
on the Fluid Head and the PAN HANDLE CLAMP , if this
occurs then unwind the PAN HANDLE CLAMP further.
1.2 Attach the MITCHELL BASE ADAPTOR (#1225) to the
CLAW BALL, as shown, and tighten the three M5 screws
using a 4mm Hex Key.
1.3 Ensure that the TRIPOD is level, adjust the TRIPOD if
necessary, such that the bubble is inside the black circle
(fig. 5).
1.4 Place the LOCATION BOSS into one of the three LOCATION
SLOTS and tighten the CLAMP NUT.
1.5 Set the initial control settings as follows – see Figure 1 & 2:
 Select Counterbalance to position 8 (top setting).
 Select Pan & Tilt Drag to position 0.
 Tighten the PAN LOCK and TILT LOCK.
6
Pan Handle Clamp
Pan Handle
Illumination Button
Bubble Level
Clamp Nut
Fig. 4