Miller 1055 Посібник оператора - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник оператора для Аксесуари для фотоапаратів Miller 1055. Miller 1055 17 сторінок. Fluid head

Operating Instructions

The operating instructions are described in six steps. Please

read and understand these instructions before using this

equipment. Do not omit any steps.

The Cineline 70 Fluid Head can be mounted on a 150mm

TRIPOD BOWL or on a MITCHELL BASE.

1 Fluid Head Set-up (Mitchell Base)

1.1 Loosen the PAN HANDLE CLAMP fully then rotate the

PAN HANDLE until it is approximately perpendicular to the

THREADED STUD (fig. 1) and tighten the PAN HANDLE

CLAMP - avoid contact wear between the serrations

on the Fluid Head and the PAN HANDLE CLAMP , if this

occurs then unwind the PAN HANDLE CLAMP further.

1.2 Attach the MITCHELL BASE ADAPTOR (#1225) to the

CLAW BALL, as shown, and tighten the three M5 screws

using a 4mm Hex Key.

1.3 Ensure that the TRIPOD is level, adjust the TRIPOD if

necessary, such that the bubble is inside the black circle

(fig. 5).

1.4 Place the LOCATION BOSS into one of the three LOCATION

SLOTS and tighten the CLAMP NUT.

1.5 Set the initial control settings as follows – see Figure 1 & 2:

 Select Counterbalance to position 8 (top setting).

 Select Pan & Tilt Drag to position 0.

 Tighten the PAN LOCK and TILT LOCK.

Pan Handle Clamp

Pan Handle

Illumination Button

Bubble Level

Clamp Nut

Fig. 4