Miller 480 Руководство по эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Аксессуары для фотоаппаратов Miller 480. Miller 480 8 страниц. Combination pedestal

Печатать страницу

SET-UP (CONT)

•

Peel off Miller label (if applicable) from the dolly

centre hub to reveal the 12.5mm hole. (Fig 4.)

•

Remove Pedestal Column and Spider Legs from

the packing box.

•

Line up Column to the dolly centre hub, insert M12

bolt into the 12.5mm hole. (Fig 5.&6.)

•

Tighten the bolt but not fully with the supplied

10mm Hexagon Key.

•

Align the Spider Foot on to the ball of dolly end

(Fig 7.). Pull the Rubber Stirrup up and over the

end shoulder of Spider Foot. (Fig 8.) Repeat for the

remaining two spider legs.

•

Fully tighten the bolt and check that the Column is

secure.

•

Raise and lock the (airless) Pedestal Column in the

highest position using the Column Clamp Handle.

•

Use a High Pressure Pump and connect it to the

Schrader Valve on the Air Pressure Block. (Fig 9.)

Fig 6.

Fig 9.

Fig 7.

Using pump bring the air pressure to the desired level

depending on the camera load that is going to be used.

During detaching of the pump there is some air leaving

the system, therefore, we recommend putting extra air in

the system and let some air out when fine tuning balance

of the camera with its accessories.

Now the Combination Pedestal is set up in its standard

configuration on the Miller Studio Dolly range.

Fig 4.

Fig 5.

Fig 8.