Aquatec OCEAN VIP Commode Руководство по эксплуатации - Страница 8
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Инвалидное кресло Aquatec OCEAN VIP Commode. Aquatec OCEAN VIP Commode 10 страниц. Commode
Печатать страницу
6.5
Adjusting the backrest cover
Important!
●
The lower seam (5, fig. 10) of the backrest
cover must always be below the distance
piece (6, fig. 10) of the backrest frame (4,
fig. 10).
●
To attach accessories, the second belt lock
can be opened from above and the back-
rest cover can be passed by the backrest
frame on the inside at this point (3, fig. 10).
●
At least three belts must always be passed
by the backrest frame (on the outside) and
their belt locks must be closed.
The backrest tension can be individually adjusted.
Tensioning:
Tighten the belts (1, fig. 10) of the backrest cover.
Loosening:
1.
Open the belt locks (2, fig. 10) by pressing the
lugs (arrow, fig. 10).
2.
Push the belt back through the lock.
3.
Close the belt locks.
4.
Slightly tension the belt.
6.6
Use
When using the commode, observe the following safe-
ty rules:
CAUTION!
●
Seat surface may slip if loose
Check whether the seat surface is firmly
secured to the seat frame before use.
●
Slipping caused by the chair rolling
Lock the casters using the red foot ped-
als before getting into or out of the chair.
Rolling away
Lock the casters with the red foot pedals in
parked position.
14
CAUTION!
Tipping over
●
Push the footrests to the sides or fold up
the foot plates before getting into or out
of the chair.
●
Swivel the front casters so that the lock
is pointing forwards before getting into or
out of the chair.
●
Do not stand on the footrests.
●
Only drive the user on the commode
when the seat frame and backrest are
fixed in the upright position.
●
Never remove the pneumatic springs.
Risk of breakage during transport
●
Only lift the commode by the sides when
someone is sitting in it.
●
Use only the handle on the backrest to
steer or push the commode, never the
head support.
6.7
Folding the arm rests
CAUTION!
Risk of catching due to folding mechanism
●
When folding down the armrests, do not
reach into the joint, and make sure that
no parts become jammed.
●
When folding up the armrests, do not
reach between the armrest and the
backrest.
6.8
Folding the footrests
Position for getting in and out:
1.
Push the footrest slightly upwards along the guide
until the groove (2, fig. 6) no longer catches the
pin of the clip (7, fig. 6).
2.
Fold the footrest to the side.
Driving position:
CAUTION!
Loose footrests can be dangerous
Fix the footrests in the driving position.
1.
Turn the footrests inwards.
2.
Push down the footrest until the groove (2, fig. 6)
catches the pin of the clip (7, fig. 6).
EN