Olympus IX71 Руководство по установке - Страница 4

Просмотреть онлайн или скачать pdf Руководство по установке для Микроскоп Olympus IX71. Olympus IX71 11 страниц. Microscope z-axis motor drive
Также для Olympus IX71: Брошюра и технические характеристики (16 страниц)

Печатать страницу

Last update: 2021/09/23 17:15

unscrewed, note if there is a small silver wave spring washer adhered to it; if so, remove the

washer from the focus knob and place it on to the brass assembly located within the coarse

focus knob.

Part-2: Installing Flexible Coupling and Baseplate

Slide ﬂexible coupler over threaded end of ﬁne focus shaft while holding right hand knob in place.

Tighten clamp on ﬂexible coupler while holding right hand knob in place.

Slide ﬂexible coupler over the threaded end of the left ﬁne focus shaft while holding the right ﬁne

focus knob in place, and tighten clamp with a 2 mm or 5/64 inch Allen wrench. Ensure that it is

pressed all the way against the brass part of the left microscope knob without pushing the right focus

knob out on the other side. Check for any play in the focus shaft by pushing and pulling the focus

knob as shown on the left – no movement should be evident.

Part-3: Installing and Aligning the Z-axis Motor Drive

If shipped assembled, use the 7/64 inch Allen wrench and disassemble the Z-drive motor

assembly from base plate by removing the horizontal adjustment screw. At this time, also

loosen the two vertical adjustment screws.

https://asiimaging.com/docs/

olympus_ix71_zdrive_install https://asiimaging.com/docs/olympus_ix71_zdrive_install

Printed on 2022/01/10 05:45