Axminster AWVSWL1200D Руководство пользователя - Страница 9
Просмотреть онлайн или скачать pdf Руководство пользователя для Токарный станок Axminster AWVSWL1200D. Axminster AWVSWL1200D 19 страниц. Woodturning lathe
Печатать страницу
9
speed, where as the "Low" speed range (100-1200) will provide maximum torque.
4. Lower the tensioning handle so that the weight of the motor provides the needed
tension and tighten the locking handle.
Fig.9
The following directions will give the inexperienced operator a beginning point for
common lathe operations. Practice on scrap material before attempting serious work.
LATHE TOOLS
Standard wood turning tools come in several different configurations (Fig. 10). The
majority of turnings will require the gouge tool (A) Fig. 10. This round nosed hollow
chisel is used for roughing cuts, cove cuts and other operations. The skew chisel (B)
is a double-ground flat chisel, with an angled end. This tool is used for smoothing
cylinders, for cutting shoulders, beads, vee grooves, etc. The parting tool (C) is a
double-ground chisel, used for cutting-off, or for making straight incisions or sizing
cuts to any required diameter. The round nose scraper (D) is used for mostly
hollowing work, while the square-end scraper is mainly used for the outside of bowls.
Fig.11
HOW TO TURN SPINDLES
Working with any material that is attached to the lathe centers is called a spindle
turning. This is the principal type of wood turning (chair and table legs, lamp stems,
etc.) The turning of spindles can be done with either a scraping or cutting technique.
WOODLATHE MANUAL
OPERATION
Fig.10
Fig.12