Axminster AWVSWL1200D 사용자 설명서 - 페이지 9

{카테고리_이름} Axminster AWVSWL1200D에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster AWVSWL1200D 19 페이지. Woodturning lathe

speed, where as the "Low" speed range (100-1200) will provide maximum torque.

4. Lower the tensioning handle so that the weight of the motor provides the needed

tension and tighten the locking handle.

Fig.9

The following directions will give the inexperienced operator a beginning point for

common lathe operations. Practice on scrap material before attempting serious work.

Standard wood turning tools come in several different configurations (Fig. 10). The

majority of turnings will require the gouge tool (A) Fig. 10. This round nosed hollow

chisel is used for roughing cuts, cove cuts and other operations. The skew chisel (B)

is a double-ground flat chisel, with an angled end. This tool is used for smoothing

cylinders, for cutting shoulders, beads, vee grooves, etc. The parting tool (C) is a

double-ground chisel, used for cutting-off, or for making straight incisions or sizing

cuts to any required diameter. The round nose scraper (D) is used for mostly

hollowing work, while the square-end scraper is mainly used for the outside of bowls.

Fig.11

Working with any material that is attached to the lathe centers is called a spindle

turning. This is the principal type of wood turning (chair and table legs, lamp stems,

etc.) The turning of spindles can be done with either a scraping or cutting technique.

WOODLATHE MANUAL

OPERATION

Fig.10

Fig.12