Accurate Technology Digi-Stop Руководство пользователя - Страница 6

Просмотреть онлайн или скачать pdf Руководство пользователя для Измерительные приборы Accurate Technology Digi-Stop. Accurate Technology Digi-Stop 16 страниц. Complete digital stop and fence system for chop saws, radial arm saws, and miter saws

Печатать страницу

ECTION

Assembly & Mounting

Digi-Stop is easy to install. By following the basics of good installation reliable,

error-free operation can be expected.

1. Carefully slide the encoder onto the Scale.

2. Loosen the locking knob and slide the Stop assembly into the fence

extrusion.

3. Position the encoder and Stop together and slide the encoder under the

Guide Clip so the post on the encoder is captured in the slot of the Guide

Clip, as shown below

4. Attach the readout to the aluminum block on the stop using the enclosed

strips of Velcro. Plug the encoder into the readout .

5. Position the fence system so it is 90 degrees with respect to the blade and

bolt it to your table by inserting the included nuts into the T slot on the

bottom of the fence extrusion and using the bolts to mount the fence to

your table from the bottom.

6. Move the stop assembly left to right and note if the readings increase or

decrease. Depending upon the installation (left or right infeed), it may be

necessary to reverse the reading direction.

See Section 3: Reverse Readings

Manual Part # 800-1070-001, Rev G, 10-2008

NSTALLATION

Page 6 of 16