ABB i-bus 6164 U-500 Руководство по эксплуатации - Страница 9

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Контроллер ABB i-bus 6164 U-500. ABB i-bus 6164 U-500 11 страниц. Eib heating actuator

Печатать страницу

Mounting Instructions

If the physical address has not yet been assigned,

the programming key (Fig. 2) should remain

accessible.

Do not cut in the required 230-V power supply before

all connections have been properly hooked up and

insulated!

The unit can be mounted in a cable duct with two

combined wall and joint boxes (due to separation of

low voltage and 230-V system).

For flush-mounted installation two deep double boxes

or one electronic box (eg. Kaiser make) can be used.

With both installation methods the connecting leads

for the positioner (servo-drive) are run out of the box

via central disk 2527-xx or 1749-xx.

Connection must only be effected via push-lock

(screwless) box terminals .

To adhere to the safety class specified under

„ Technical Data" the connecting terminals have to

be placed inside the mounting boxes.