ABB i-bus 6164 U-500 Kullanım Talimatları Kılavuzu - Sayfa 9

Kontrolör ABB i-bus 6164 U-500 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. ABB i-bus 6164 U-500 11 sayfaları. Eib heating actuator

Mounting Instructions

GB
If the physical address has not yet been assigned,
the programming key (Fig. 2) should remain
accessible.
Do not cut in the required 230-V power supply before
all connections have been properly hooked up and
insulated!
The unit can be mounted in a cable duct with two
combined wall and joint boxes (due to separation of
low voltage and 230-V system).
For flush-mounted installation two deep double boxes
or one electronic box (eg. Kaiser make) can be used.
With both installation methods the connecting leads
for the positioner (servo-drive) are run out of the box
via central disk 2527-xx or 1749-xx.
Connection must only be effected via push-lock
(screwless) box terminals .
To adhere to the safety class specified under
„ Technical Data" the connecting terminals have to
be placed inside the mounting boxes.