Axxess AX-TYAMP1-SWC Руководство по установке - Страница 3
Просмотреть онлайн или скачать pdf Руководство по установке для Усилитель Axxess AX-TYAMP1-SWC. Axxess AX-TYAMP1-SWC 8 страниц. Lexus/toyota amp interface with swc 2002-2015
Печатать страницуConnections to be made (Cont)
3.5mm jack steering wheel control retention:
• The 3.5mm jack is to be used to retain steering wheel controls.
•
For the radios listed below, connect the included female 3.5mm connector with stripped leads onto
the male 3.5mm SWC jack of the AX-TYAMP1-SWC. Any remaining wires, tape off and disregard :
•
Eclipse: Connect the steering wheel control wire, normally Brown, to the Brown/White
wire of the connector. Then connect the remaining steering wheel control wire, normally
Brown/White, to the Brown wire of the connector .
•
Metra OE: Connect the steering wheel control Key 1 wire (Gray) to the Brown wire.
•
Kenwood or select JVC with a steering wheel control wire: Connect the Blue/
Yellow wire to the Brown wire.
Note: If your Kenwood radio auto detects as a JVC, manually set the radio type to
Kenwood. See the instructions under changing radio type.
•
XITE: Connect the steering wheel control SWC-2 wire from the radio to the Brown wire.
•
Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the AX-SWC-PARROT (sold
separately), and then connect the 4-pin connector from the AX-SWC-PARROT into the radio.
Note: The radio must be updated to rev. 2.1.4 or higher software.
•
Universal "2 or 3 wire" radio: Connect the steering wheel control wire, referred to as
Key-A or SWC-1, to the Brown wire of the connector. Then connect the remaining steering
wheel control wire, referred to as Key-B or SWC-2, to the Brown/White wire of the
connector. If the radio comes with a third wire for ground, disregard this wire
Note: After the interface has been programmed to the vehicle, refer to the manual
provided with the radio for assigning the SWC buttons. Contact the radio manufacturer
for more information.
• For all other radios: Connect the 3.5mm jack of the AX-TYAMP1-SWC into the jack on
the aftermarket radio designated for an external steering wheel control interface. Please
refer to the aftermarket radios manual if in doubt as to where the 3.5mm jack goes to.
®
AX-TYAMP1-SWC
Installing the AX-TYAMP1-SWC
With the key in the off position:
• Connect the 16-pin harness with stripped leads, and the AX-TYAMP1-SWC
harness, into the interface.
• Connect the AX-TYAMP1-SWC harness to the wiring harness in the vehicle.
Note: If retaining steering wheel controls, ensure the jack/wire is
connected before proceeding to the next step.
.