Digilent chipKIT uC32 Справочное руководство - Страница 6

Просмотреть онлайн или скачать pdf Справочное руководство для Материнская плата Digilent chipKIT uC32. Digilent chipKIT uC32 18 страниц.

chipKIT™ uC32™ Board Reference Manual

chipKIT uC32 Hardware Description

3.1

MPIDE and USB Serial Communications

The uC32 board is designed to be used with the Multi-Platform IDE (MPIDE). MPIDE is a modified version of the

Arduino IDE that supports the PIC32 microprocessors and is backwards-compatible with the Arduino IDE. The

MPIDE uses a serial communications port to communicate with a boot loader running on the uC32 board. The

serial port on the uC32 board is implemented using an FTDI FT232R USB serial converter. Before attempting to use

the MPIDE to communicate with the uC32, the appropriate USB device driver must be installed.

The uC32 board uses a standard mini-USB connector for connection to a USB port on the PC. When the MPIDE

needs to communicate with the uC32 board, the board is reset and starts running the boot loader. The MPIDE then

establishes communications with the boot loader and downloads the program to the board.

When the MPIDE opens the serial communications connection on the PC, the DTR pin on the FT232R chip is driven

low. This pin is coupled through a capacitor to the MCLR pin on the PIC32 microcontroller. Driving the MCLR line

low resets the microcontroller, restarting execution with the boot loader.

This automatic reset action (when the serial communications connection is opened) can be disabled. To disable

this operation, there is a cuttable trace on the bottom of the board between the pins on JP1. JP1 is normally not

loaded. If the trace between the pins on JP1 has been cut, the automatic reset operation can be restored by

loading JP1 and inserting a shorting block across it.

Two red LEDs (LD1 and LD2) will blink when data is being sent or received between the uC32 and the PC over the

serial connection.

The header connector J3 provides access to the other serial handshaking signals provided by the FT232R.

Connector J3 is not loaded at the factory and can be installed by the user to access these signals.

3.2

Power Supply

The uC32 is designed to be powered either via USB or from an external power supply. There is an automatic

switch-over circuit that causes the external supply to be used if both supplies are present.

The power supply section in the uC32 uses two voltage regulators. The first regulates the external voltage to 5V to

power the VCC5V0 bus. The second regulates the VCC5V0 bus to 3.3V to provide power to the VCC3V3 bus that

powers the PIC32 microcontroller.

The 5V voltage regulator is normally an NCP1117. The board is designed to be able to also use an LM1117, but the

NCP1117 is the part normally used. The NCP1117 is rated for an output current of 1A (the LM1117 is rated for

800mA). The dropout voltage of the NCP1117 is a maximum of 1.2V at the rated output current (1.3V for the

LM1117).

There is a reverse polarity protection diode in the external power supply circuit. Considering the diode drop plus

the forward drop across the regulator, the minimum input voltage to the regulator should be 7V to produce a

reliable 5V output. The absolute maximum input voltage of both the NCP1117 and the LM1117 is 20V. The

recommended maximum operating voltage is 15V.

Other product and company names mentioned may be trademarks of their respective owners.

Page 6 of 17