Digimerge DND7220 Series Руководство по быстрой установке - Страница 3

Просмотреть онлайн или скачать pdf Руководство по быстрой установке для Камера безопасности Digimerge DND7220 Series. Digimerge DND7220 Series 20 страниц. High resolution dual-codec vandal resistant day/night dome network camera

Печатать страницу

• Hardware installation:

A. Installing the Base

B. Adjusting the Lens

C. Connecting the Cables

• Software installation

• Network configuration

Hardware Installation - Installing the Base

NOTES:

• If you wish to change the Cable Location (Cable

Conduit), please refer to User Manual Appendix #2

prior to installation.

• Do not remove the Dome Cover Plastic Protector

until the end of the installation.

1. Remove the Cover from the Camera by removing

the 4 securing screws using the large silver

proprietary Hex Tool.

2. Attach the base to a Wall or Ceiling:

i. Hold the base up to the desired location. Use a

Pencil or Marker to mark the 4 hole locations.

ii. Use a drill with the correct bit type, and drill

holes on the marked positions. Hammer the

Screw Plugs (included with the Hardware Pack)

into the holes.

iii. Place the rubber washer onto the screw (both

provided with the Hardware Pack). Repeat for all

screws.

iv. Use a screwdriver to install the 4 screws through

the holes in the base into the mounting surface.

w w w

d i g i m e r g e

c o m

DND70 Series_Quick Installation Guide_En_R1

HARDWARE CONNECTIONS

Page

2ii

2iii

2iv